Blue-sea-systems 8015 DC analog Voltmeter Panel - 8 to 16V DC User Manual download pdf

8-16 Volts PN 8003 / PN 8028

Meter Specications

Input Voltage: 8 Volts DC to 16 Volts DC

Amperage Draw: 1 Milliampere

Display: Analog scale 8-16 Volts

Accuracy: 3% of scale range (.24 Volt)

PN Inches Millimeters

Face Width: 8003 2-1/2 63.50

8028 2 50.80

Mounting Hole: 8003 1-7/8 47.60

8028 1-1/2 38.10

Guarantee

Any Blue Sea Systems product with which

a customer is not satised may be returned

for a refund or replacement at any time.

Marine Electrical Prod

ucts

Warning

It is not possible within the scope of these

instructions to fully acquaint the installer

with all the knowledge of electrical systems

that may be necessary to correctly install

this product. If the installer is not

knowledgeable in electrical systems we

recommend that an electrical professional

be retained to make the installation.

1. Disconnect all AC and DC power

Before starting, disconnect the main

positive cable from all batteries to eliminate

the possibility of a short circuit while

installing the meter panel. Also disconnect

the AC shore power cord from the boat to

eliminate the possibility of electrocution

from AC wiring near the DC meter.

2. Select mounting location and

cut opening

Select a mounting location which is

protected from water on the meter front and

back and is not in an area where ammable

vapors from propane, gasoline or lead acid

batteries accumulate. The meter is not

ignition protected and may ignite such

vapors. There are two mounting methods

for the 8028 and 8003 meters, surface

mount or panel mount.

Blue Sea Systems Inc.

425 Sequoia Drive Bellingham, WA 98226 USA

Phone (360) 738-8230 Fax (360) 734-4195

E-mail [email protected]

www.bluesea.com

(

Installation (continued)

Analog DC Voltmeter

Document 9310 Rev.D

PN 8028

PN 8003

Surface Mount

Panel Mount

3. Surface Mount: Drill ve clearance holes as shown below. The part number of the meter will

determine the size and location of the clearance holes. Use the nuts and washers supplied in the

accessory package to secure the four mounting studs to the mounting surface. This method will

work on mounting surfaces up to 5/8” thick.

Installation

PN 8028

Micro Meter

PN 8003

Standard Meter

1 2

Summary of Contents

Page 1 - Installation

8-16 Volts PN 8003 / PN 8028Meter Specications Input Voltage: 8 Volts DC to 16 Volts DCAmperage Draw: 1 MilliampereDisplay: Analog scale 8-16 V

Page 2 - Use of Voltmeter

4. Panel Mount: For thicker mounting surfaces, the meter can be mounted into a 0.125” thick panel. Blue Sea Systems offers meter mounting panels

Comments to this Manuals

No comments

Blue-sea-systems 8015 DC analog Voltmeter Panel - 8 to 16V DC User Manual

Browse online or download User Manual for Control panel Blue-sea-systems 8015 DC analog Voltmeter Panel - 8 to 16V DC. Blue Sea Systems 8015 DC analog Voltmeter Panel - 8 to 16V DC User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Control panel Blue-sea-systems 8015 DC analog Voltmeter Panel - 8 to 16V DC